Independent · Multi-brand
Northeast Florida
Mon–Fri 8–6 · Sat 9–4
Dominant stressor · Humidity
Panel-ready refrigeration is sealed into cabinetry in a climate that runs a 70-degree dew point for five months. The failures follow from that.
Dominant stressor · Heat load
An ice machine runs a freeze cycle and a harvest cycle against a Florida summer. Which of the two has stopped working decides the whole diagnosis.
Dominant stressor · Humidity
Half the dishwashers we are called to are working correctly and installed badly. Telling those two apart is the first thing the diagnostic does.
Dominant stressor · Power loss
An oven that bakes long is a measurement problem first. We probe the cavity through a full cycle before deciding what, if anything, is broken.
Dominant stressor · Heat load
Ventilation is a humidity control device here, not just a smoke extractor. When it stops capturing, the refrigerator three feet away notices.
Rated 4.6 out of 5 across 101 customer reviews. Every entry below is one appointment, written up afterwards by the householder whose kitchen it happened in.
One from each of three different categories, picked from the URL rather than chosen.
One burner kept clicking and refusing to stop sparking. He replaced the spark module and dried out the ignition harness, and explained why our damp winters bring that fault on. It has lit normally since.
Beatrix G.2026-03-05
An older kitchen where the appliance had been squeezed into a cabinet that was never built for it. He explained why the clearance was strangling the heat rejection before touching a part, and the rebuilt airflow path fixed the warm shelf.
Marguerite F.2026-03-19
Baking was uneven front to back in a wall oven set into an older cabinet. He checked the cavity temperature, the door seal and the installation clearance together, and the fix turned out to be the seal and the levelling.
Delphine K.2026-06-28
One fee to find out: $80, flat, and it comes off the bill the moment you say go ahead. Past that, built-in appliance work across this coast sits between $240 and $670, and where inside that band a job lands is decided by the part that failed rather than by the badge on the door.
The category page narrows this table to the repairs that category generates.
| Repair | Parts and labor |
|---|---|
| Diagnostic visit, flat | $80 |
| Ice maker, water valve or supply line | $240–$670 |
| Evaporator or condenser fan motor | $280–$600 |
| Door gasket or seal replacement | $240–$600 |
| Defrost heater, thermostat or sensor | $240–$610 |
You get a written estimate before any part is ordered or any labor begins. Nothing proceeds without your approval.
$80 to come out and find the fault, credited back the moment the repair is approved. The work itself lands between $240 and $670 on this kind of equipment — $240–$670 for ice maker, water valve or supply line, $240–$610 for defrost heater, thermostat or sensor — and which of those it turns out to be is the thing the visit settles. Your own number goes in writing before a part is ordered.
Duval County, St. Johns County, Clay County, Nassau County. Roughly a 40-mile working radius from the Jacksonville core. $80 flat diagnostic fee, credited toward the repair when you approve the work.
Our own work carries 90 days on labor and 365 days on the parts we fit, and we fit genuine OEM parts only. That is our warranty rather than a manufacturer warranty, and it neither extends nor replaces one. If the same fault comes back inside those terms, the return visit is ours.
Describe the symptom rather than the diagnosis. "The freezer is fine and the refrigerator is warm" narrows a built-in unit to one sealed circuit. "The glasses came out chalky" is a water question before it is a dishwasher question. "It stopped the morning the power came back" is an electronics question. We would rather sort that out on the phone than send a technician to the wrong appliance.